In Design Space, open the Hey Pumpkin cut file and adjust the size if you'd like. Click Make it and mirror the image.

Place the Infusible Ink transfer sheet onto the cutting mat liner (shiny, non-patterned) side down. Load the mat into machine and press the flashing GO button.

Remove the cut design from the mat and trim away unused area of sheet. Gently roll the cut design so the cut lines separate and are more visible. “Cracking” the cut like this makes it easier to grasp and remove excess paper from in and around your design. Make sure your hands are completely dry before weeding. Use tweezers or your fingers to carefully weed negative pieces from in and around your design, leaving the design on the liner. Trim the clear liner so that it does not extend beyond Cricut EasyPress heat plate.

Set your EasyPress to 385º F. The EasyPress 2 12" x 10" is the perfect size for the pillow cover blanks. You want to make sure the entire design is covered; you don't want to overlap the heat on an area or the results may look inconsistent.

Place the pillow cover blank on the Cricut EasyPress mat. Position a sheet of card stock inside the pillow cover where the design will be to protect the pillow case and mat.

Use a fresh adhesive lint roller and roll the entire surface of the pillow cover. Even the smallest debris or fibers can create imperfections in the Infusible Ink transfer.

Press at 385º F for 60 seconds with light pressure.

Slowly lift the EasyPress, remove the butcher paper and remove the liner while still warm.